38 - FORM NO. 56043124 - Condor XL
™
TABLE 1 – CONTROL BOARD CONNECTORS
Note: Also refer to the I/O Tables in the Appendix
Condor XL J1 Main Control Board Connectors
Pin# Wire# Color Type Goes to
J1-1 18-1 GRA input Engine control module output (run signal)
J1-2 20-1 BLK/YEL -CANbus User interface panel (membrane switches)
J1-3 20-1 ORN/BLK +CANbus User interface panel (membrane switches)
J1-4 Open
J1-5 Open
J1-6 Open
J1-7 18-1 GRA/BLK input Fuel level sensor for either petrol/diesel,/LP
J1-8 Open
J1-9 Open
J1-10 18-1 BRN/WHT output Foot pedal position potentiometer (sensor high)
J1-11 18-1 YEL/GRA output Foot pedal position potentiometer (sensor low)
J1-12 18-1 ORN/GRN input Key switch ignition switch (run)
J1-13 Open
J1-14 Open
J1-15 Open
J1-16 18-1 RED/BLK input S29 Horn switch
J1-17 Open
J1-18 16-1 BLK ground Chassis ground X-49
J1-19 18-1 GRN/ORN input Sender hydraulic oil temperature
J1-20 18-1 VIO/WHT input S6 Brake switch
J1-21 18-1 VIO/YEL input S3 Solution empty switch
J1-22 18-1 WHT/BRN output Relay PCB (start inhibit pin #J7-3)
J1-23 Open
J1-24 18-2 VIO/BRN input Ignition switch start position
J1-25 18-1 GRN/YEL input Engine control module (MIL output signal)
J1-26 Open
J1-27 18-1 GRA/YEL input S2 Recovery tank full switch
J1-28 Open
J1-29 Open
J1-30 18-1 VIO/BLU input Engine control module (engine coolant temperature out-
put)
J1-31 18-1 ORN/GRA input Foot pedal position potentiometer (sensor wiper)
J1-32 18-1 RED/YEL input S4 Hydraulic fi lter switch
J1-33 18-1 BRN/BLU input S7 Extend scrub level switch
J1-34 18-1 YEL/WHT output Relay PCB (ignition inhibit pin #J7-7)
J1-35 Open
To Next Page
Loading...
Need help?
General
