Nokia 7210 - Page 446

System Management
446
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
© 2021 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 17358 AAAB TQZZA
Using the weekday command as well as the day-of-month command will cause the script to
run twice. For example, consider that “today” is Monday January 1. If “Tuesday January 5” is
configured, the script will run on Tuesday (tomorrow) as well as January 5 (Friday).
See the month, weekday, hour, and minute commands for more information.
The no form of this command removes the specified day-of-month from the list.
Parameters day-number — Specifies the day. The positive integers specify the day of the month
counting from the first of the month. The negative integers specify the day of the
month counting from the last day of the month. For example, configuring day-of-
month -5, 5 in a month that has 31 days will specify the schedule to occur on the 27th
and 5th of that month.
Integer values must map to a valid day for the month in question. For example,
February 30 is not a valid date.
Values 1 to 31, -31 to -1 (maximum 62 day-numbers)
all — Specifies all days of the month.
end-time
Syntax end-time [date | day-name] time
[no] end-time
Context config>system>cron>sched
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command is used concurrently with type periodic or calendar. Using the type of
periodic, end-time determines at which interval the schedule will end. Using the type of
calendar, end-time determines on which date the schedule will end.
When no end-time is specified, the schedule runs forever.
Parameters date — Specifies the date to schedule a command.
Values YYYY:MM:DD in year:month:day number format
day-name — Specifies the day of the week to schedule a command.
Values sunday, monday, tuesday, wednesday, thursday, friday, saturday
time — Specifies the time of day to schedule a command.
Values hh:mm in hour:minute format
hour
Syntax hour {..hour-number [..hour-number] | all}