7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
System Management
3HE 17358 AAAB TQZZA © 2021 Nokia.
Use subject to Terms available at: www.nokia.com
535
acl-sap-ingress
Syntax acl-sap-ingress [num-resources]
no acl-sap-ingress
Context configure>system>resource-profile>ingress-internal-tcam
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command allocates maximum resources for use by ingress filter policies using any of the
supported match criteria. This command limits the total amount of chunks allocated for use
by ingress filter policies to the value specified by num-resources. In other words, the
cumulative sum of chunks allocated to different match criteria supported by ingress filter
policies cannot exceed the value configured with num-resources.
Ingress ACL resources are shared with SAP ingress aggregate meter. See the sap-
aggregate-meter command for more information.
The no form of this command removes any allocated resources for use by filter policies.
Consequently, the software fails all attempts to associate a service entity (for example, SAP
and IP interface) with a filter policy using any of the match criteria.
Parameters num-resources — Specifies the amount of resources that can be allocated for use by
ACL policies.
Note:
• In some scenarios, reassigning a chunk of resources among features may require the
node to be rebooted. See the CLI description of the specific feature for more
information.
• The ingress internal TCAM pool of resources is available per node on the 7210 SAS-M,
7210 SAS-T, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE (standalone), and
7210 SAS-Sx 10/100GE. On the 7210 SAS-Sx/S 1/10GE (standalone-VC),
7210 SAS-R6, and 7210 SAS-R12, it is available as a per-IMM pool of resources.
• The number of chunks and the number of resources per chunk varies among the
different platforms. Contact your Nokia technical support representative for more
information.
• To be enabled, some features require the allocation of a specific number of chunks
(greater than 1). If the minimum number of chunks is not assigned, the system cannot
allocate the required resources to the feature, which causes the command associated
with the feature to fail.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
