System Management
540
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
© 2021 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 17358 AAAB TQZZA
Parameters num-resources — Specifies the maximum amount of resources for use by this match
criteria.
If the user specifies max, the software allocates one chunk when the first SAP is
associated with an ingress filter policy using this match criteria. It continues to
allocate resources to SAPs associated with an ingress filter policy using this criteria,
as long as the total amount of resources allocated does not exceed the resources
allocated to ingress filter policies (configured with the config system resource-
profile ingress-internal-tcam qos-sap-ingress-resource command) and chunks
are available for use.
Values Table 52 lists the parameter values.
ipv4-match-enable
Syntax ipv4-match-enable num-resources
no ipv4-match-enable
Context configure>system>resource-profile>ingress-internal-tcam>acl-sap-ingress
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Table 52 Number of Resources Available for IPv4-MAC-Match-Enable
Platforms Min value
(per node)
Max value
(per node)
Default
Values
7210 SAS-M (per node) 0 10 max
7210 SAS-T access-uplink mode (per node) 0 7 max
7210 SAS-T network mode (per node) 0 6 max
7210 SAS-R6 (per IMMv1) 0 7 max
7210 SAS-R6 and 7210 SAS-R12 (per IMMv2) 0 12 max
7210 SAS-R6 and 7210 SAS-R12 (per IMM-c) 0 10 max
7210 SAS-Mxp (per node) 0 10 max
7210 SAS-Sx 1/10GE (per node) (standalone) 0 7 max
7210 SAS-Sx 1/10GE (standalone-VC) 0 6 max
7210 SAS-S 1/10GE (per node) (standalone) 0 7 max
7210 SAS-S 1/10GE (standalone-VC) 0 6 max
7210 SAS-Sx 10/100GE (per node) 0 3 max
To Next Page
Loading...
