System Management
654
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
© 2021 Nokia.
Use subject to Terms available at: www.nokia.com
3HE 17358 AAAB TQZZA
synchronization
Syntax synchronization
Context show>redundancy
Platforms 7210 SAS-R6, 7210 SAS-R12, and 7210 SAS-Sx/S 1/10GE: standalone-VC
Description This command displays redundancy synchronization times.
Output The following output is an example of redundancy synchronization information, and Table 88
describes the output fields.
Sample Output
A:ALA-48>show>redundancy# synchronization
===============================================================================
Synchronization Information
===============================================================================
Standby Status : disabled
Last Standby Failure : N/A
Standby Up Time : N/A
Failover Time : N/A
Failover Reason : N/A
Boot/Config Sync Mode : None
Boot/Config Sync Status : No synchronization
Last Config File Sync Time : Never
Last Boot Env Sync Time : Never
===============================================================================
A:ALA-48>show>redundancy#
Rem Alarm Entries Displays alarm entries on the remote router
Table 87 Output Fields: Multi-Chassis Sync (Continued)
Label Description
Table 88 Output Fields: Synchronization
Label Description
Standby Status Displays the status of the standby CSM
Last Standby Failure Displays the timestamp of the last standby failure
Standby Up Time Displays the length of time the standby CSM has been up
Failover Time Displays the timestamp when the last redundancy failover
occurred causing a switchover from active to standby CSM
If there is no redundant CSM card in this system or no failover has
occurred since the system last booted, the value will be 0.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
