Introduction
2‐8
P/N 397189E
E 2006 Nordson Corporation
BM200_EASY_GEAR
High Drum Jacket for Cardboard Drums
CAUTION: Do not use metal drums with this model! The drum jacket is
designed only for cardboard drums!
NOTE: Models for cardboard drums have only the lower sealing ring on the
heating punch (configuration code: box 12 = J).
Divided Base Plate for Pallet Conveyance
The bulk melter is set up on a divided base plate. This enables a drum to be
moved under the punch on a pallet.
CAUTION: Risk of damage! Do not operate equipment until it is screwed
securely to the floor. Otherwise the descending punch would lift the system
off of the floor.
To Next Page
Loading...
