Nordson BM 200 - Adjusting Switch Rod for Drum Height

2
4
5
6
3
1
Operation
4‐2
P/N 397189E
E 2006 Nordson Corporation
BM200_EASY_GEAR
Adjusting Switch Rod
Set the switch rod (2) such that it activates switch 4 when the upper sealing
ring (3) is completely submerged in the drum. To do this, release hexagonal
socket screw (1).
NOTE: Models for cardboard drums have only the lower sealing ring on the
heating punch (configuration code: box 12 = J).
Setting the switch rod adjusts the system to the drum height used. The switch
rod activates the switches (4, 5 and 6) one after the other and thus triggers
the following switching functions:
Switching Functions when Lowering
S Switches from two‐hand lowering mode to normal lowering mode when
the sealing ring (3) is completely submerged in the drum (switch 4).
S Triggers the drum almost empty indication (switch 5).
S Triggers the drum empty indication (switch 6).
Switching Functions when Raising
S Switches off the automatic drum aeration (switch 4).