Operation
4‐4
P/N 397189E
E 2006 Nordson Corporation
BM200_EASY_GEAR
Inserting and Replacing Drum
CAUTION: Place only undamaged, suitable drums in the system; otherwise
the heating punch sealing ring will be damaged. Always keep the base plate
of the system clean so that the drum is positioned straight.
WARNING: Risk of burns! Hot material can splash out when the heating
punch exits the drum. Hot material may flow out of the deaeration valve.
Wear suitable protective clothing!
NOTE: Some of the following tasks are described in detail in the subsequent
text.
1. Raise heating punch.
2. Set pneumatic switch to 0/Stop.
3. Insert or replace drum. The pneumatic switch lights up green when the
drum is inserted.
4. Lubricate sealing ring. Refer to Processing Materials in the section
Technical Data.
5. Lower heating punch.
6. Properly dispose of empty drum according to local regulations.
To Next Page
Loading...
