Maintenance
5‐1
P/N 397189E
E 2006 Nordson Corporation
BM200_EASY_GEAR
Section 5
Maintenance
WARNING: Allow only qualified personnel to perform the following tasks.
Observe and follow the safety instructions in this document and all other
related documentation.
NOTE: Maintenance is an important preventive measure for maintaining
operating safety and extending the lifetime of the unit. It should not be
neglected under any circumstances.
Risk of Burns
WARNING: Hot! Risk of burns. Wear appropriate protective
clothing/equipment. Some maintenance work can only be done when the
system is heated up.
Relieving Pressure
WARNING: System and material pressurized. Relieve system of pressure
before disconnecting heated hoses, application heads and assembly
handguns. Failure to observe can result in serious burns.
1. Set motor speed to 0 min
‐1
(rpm); switch off motor(s).
2. Place a container under the nozzle(s) of the application head/assembly
handgun.
3. Activate the application head / assembly handgun electrically or
manually. Repeat this procedure until no more material flows out.
4. Re‐use the material or dispose of properly according to local regulations.
To Next Page
Loading...
