Introduction
2‐11
P/N 397189E
E 2006 Nordson Corporation
BM200_EASY_GEAR
Electrical Connections
Also refer to section Installation and to the wiring diagram.
1
2
3
4
Fig. 2‐5
1 Additional receptacles (with option
Additional heating channels)
2 Interface Profibus (Option)
3 Receptacle XS5, tach generator
4 Interface XS2
Additional Receptacles
Depending on the model, up to three additional receptacles are available.
Two heating zones (usually for hose and application head) can be controlled
via each receptacle.
NOTE: Hose receptacles on the terminal box (Pos. 15, Fig. 2‐2) are for
hoses connected to the bulk melter heating punch.
Interface PROFIBUS (Option)
The PROFIBUS interface enables Remote operation by a higher‐ranking
control unit. Refer to separate manual.
Receptacle XS5
The receptacle is used to connect pilot voltage that regulates the system's
electrical motor synchronously to the speed of the parent machine. The pilot
voltage can be supplied e.g. by a tach generator (accessory) driven by the
parent machine. Refer to Installation.
Interface XS2
Serves as a connection between the system and external devices.
To Next Page
Loading...
