Operation
4‐3
P/N 397189E
E 2006 Nordson Corporation
BM200_EASY_GEAR
Setting Values and Parameters - Notes -
Many values and parameters are set on the control system.
For additional information, refer to control system used.
Speed, Pressure
With the option Pressure control, the speed is not regulated to a preset value;
the pressure at the material outlet is regulated.
In automatic mode, the speed and thus the output quantity is determined by a
pilot voltage. The pilot voltage is supplied e.g. by a tach generator driven by
the parent machine.
Temperatures
CAUTION: The temperature setting is determined by the processing
temperature prescribed by the adhesive supplier. The maximum operating
temperature for the product and heated components described here may not
be exceeded.
Nordson will grant no warranty and assume no liability for damage resulting
from incorrect temperature settings.
Recommended Values
The values stated in the tables are general values determined by experience;
deviation may prove necessary.
Heating zone / temperature / time
Setting
Heating punch 10 ° C (18 ° F) below prescribed processing temperature
Undertemperature value 10 ° C (18 ° F) (deviation from setpoint)
Overtemperature value 10 to 30 ° C (18 to 54 ° F) (deviation from setpoint)
Temperature setback value (standby) As needed
Setback period As needed
Application head (accessory) Prescribed processing temperature
Heated hose (accessory) Prescribed processing temperature
To Next Page
Loading...
