Nordson BM 200 - Page 4

Table of Contents
II
P/N 397189E
E 2006 Nordson Corporation
BM200_EASY_GEAR
Installation 3‐1.............................................
Unpacking 3‐1..............................................
Lifting (Unpacked System) 3‐1..............................
Transport 3‐1...............................................
Storage 3‐2.................................................
Setting Up 3‐2..............................................
Removing 3‐3...............................................
Disposal 3‐3................................................
Exhausting Material Vapors 3‐4...............................
Electrical Connections 3‐5....................................
Laying Cable 3‐5..........................................
Line Voltage 3‐5..........................................
Power Supply 3‐5.........................................
Hose Receptacle(s) 3‐5....................................
Operating with Assembly Handguns 3‐5...................
Pilot Voltage / Tach Generator 3‐5...........................
Interface XS2 3‐6.........................................
Installing Heated Hoses 3‐7...................................
Laying Hoses 3‐7.........................................
Connecting 3‐7...........................................
Disconnecting 3‐7.........................................
Relieving Pressure 3‐7..................................
Second Open‐jawed Wrench 3‐7.........................
Pneumatic Connection 3‐8....................................
Preparing for Changeover System 3‐8..........................
Reducing Heating Punch Lifting Speed 3‐8......................
Accessories 3‐9.............................................
Light Tower 3‐9...........................................
Week Timer 3‐9...........................................
Tach Generator 3‐9.......................................
Transformer 3‐9..........................................
Operation 4‐1..............................................
Initial Startup 4‐1............................................
Adjusting Switch Rod 4‐2.....................................
Setting Values and Parameters - Notes - 4‐3....................
Speed, Pressure 4‐3......................................
Temperatures 4‐3.........................................
Recommended Values 4‐3...............................
Inserting and Replacing Drum 4‐4.............................
Raising Heating Punch 4‐5.................................
Lowering Heating Punch 4‐5................................
Switching System ON/OFF 4‐6................................
Daily Startup 4‐6..........................................
Daily Switchoff 4‐6........................................
Switching Off in an Emergency 4‐7..........................
Settings Record Form 4‐8....................................