Repair
7‐5
P/N 397189E
E 2006 Nordson Corporation
BM200_EASY_GEAR
NOTE: If the temperature sensor is defective: Continue with Step 16.
10. Remove thermostat (2) along with fastening screws and spring washers.
11. Extract connecting cable from porcelain terminals.
12. Apply heat transfer compound to contact surfaces of the new thermostat
(Refer to Processing Materials in section Technical Data), then install the
thermostat with spring washers and screws.
13. Connect thermostat wires to porcelain terminals.
14. Screw on cover.
15. Start up system.
Replacing Temperature Sensor
First perform steps 1 to 9.
16. Release nipple (4) on temperature sensor (3), then remove temperature
sensor.
17. Apply heat transfer compound to the new temperature sensor, then press
it into the nipple. Then fasten the nipple.
18. Install cover (1) again.
19. Start up system.
To Next Page
Loading...
