Nortel 5510 - Configuration - System Monitoring; Ip IpfiX Flush Command; Nortel Ethernet Routing Switch 5500 Series; Show Ip IpfiX Table Command

IPFIX Configuration using the Command Line Interface 129
ip ipfix port <port_list>
The <port_list> parameter represents a single or comma-separated
list of ports.
The ip ipfix port command is executed in the Interface Configuration
mode.
ip ipfix flush command
The ip ipfix flush command is used to delete the collected IPFIX
information for a port.
The syntax of the ip ipfix flush command is:
ip ipfix flush port <port_list> [export-and-flush]
The <port_list> parameter represents a single or comma-separated
list of ports. The export-and-flush parameter is optional and is used
to export data to a collector before it is deleted.
The ip ipfix flush command is executed in the Privileged EXEC mode.
show ip ipfix table command
The show ip ipfix table command is used to display IPFIX data
collected from the switch.
The syntax of the show ip ipfix table command is:
show ip ipfix table <unit_number> sort-by <sort_by>
sort-order <sort_order> display <num_entries>
The following table outlines the parameters of this command:
show ip ipfix command parameters
Parameter Description
<unit_number> The unit number of the collector. Currently up to two collectors
are supported so the values 1 or 2 are valid.
Nortel Ethernet Routing Switch 5500 Series
Configuration - System Monitor ing
NN47200-505 03.01 Standard
5.1 27 August 2007
Copyright © 2005 - 2007, Nortel Networks
.