Nortel 5510 - Logging Command

16 Chapter 1 General System Monitoring Considerations
show logging [config] [critical] [serious] [informational]
[sort-reverse]
The show logging command is executed in the Privileged EXEC
command mode.
" show logging parameters" (page 16) describes the parameters for this
command.
show logging parameters
Parameter Description
config Display configuration of event logging.
critical Display critical log messages.
serious Display serious log messages.
informational Display informational log messages.
sort-reverse
Display informational log messages in reverse
chronological order (beginning with most
recent).
logging command
The logging command configures the system settings for the system
event log.
The syntax for the logging command is:
logging [enable | disable] [level critical | serious |
informational | none] [nv-level critical | serious | none]
The logging command is executed in the Global Configuration command
mode.
" logging parameters" (page 16) describes the parameters for this command.
logging parameters
Parameter Description
enable | disable
Enables or disables the event log (default is
Enabled).
level critical | serious |
informational | none
Specifies the level of logging stored in DRAM.
nv-level critical | serious |
none
Specifies the level of logging stored in NVRAM.
no logging command
The no logging command disables the system event log.
Nortel Ethernet Routing Switch 5500 Series
Configuration - System Monitor ing
NN47200-505 03.01 Standard
5.1 27 August 2007
Copyright © 2005 - 2007, Nortel Networks
.