Nortel 5510 - Viewing the System Log in the Web-Based Management Interface

System logging 17
The syntax for the no logging command is:
no logging
The no logging command is executed in the Global Configuration
command mode.
default logging command
The default logging command configures the system settings as the
factory default settings for the system event log.
The syntax for the default logging command is:
default logging
The default logging command is executed in the Global Configuration
command mode.
clear logging command
The clear logging command clears all log messages in DRAM.
The syntax for the clear logging command is:
clear logging [non-volatile] [nv] [volatile]
" clear logging parameters" (page 17) outlines the parameters for this
command.
clear logging parameters
Parameter Description
non-volatile Clears log messages from NVRAM.
nv
Clears log messages from NVRAM and DRAM.
volatile Clears log messages from DRAM.
The clear logging command is executed in the Privileged EXEC
command mode.
Viewing the system log in the Web-based Management Interface
The Web-based Management Interface can be used to view the System
Log. To perform this action, follow this procedure:
Step Action
1
Open the System Log screen by selecting Fault > System Log
from the menu. This screen is illustrated in "System Log screen"
(page 18).
Nortel Ethernet Routing Switch 5500 Series
Configuration - System Monitor ing
NN47200-505 03.01 Standard
5.1 27 August 2007
Copyright © 2005 - 2007, Nortel Networks
.