61
Reference section 3 — Navigating to Waypoints
The NAV LOG screen
Reference Manual Revision D
NOTE:
Estimated times are just estimates, which
may be inaccurate if your SOG changes,
either intentionally or by passing through
varying currents.
Your ETA at the last waypoint (your desti-
nation) is shown at the top of the screen. A
darkened arrow connecting the right ends
of two waypoint boxes indicates you’ve
completed that leg of the trip.
Changing your trip
Adding waypoints to your trip
You can add waypoints to your trip at any
time:
1. On the NAV LOG screen, press the
Append waypt menu key to display a
chart view of the trip waypoints on the
APPEND WAYPT screen.
2. Press the cursor pad to select the desired
waypoint.
3. Press the Select waypt menu key, then
press the ENTER key to add the waypoint
to the nav log.
NOTE:
Any waypoints added in this manner
aren’t permanently added to the original
route stored in the 6000i. To permanently
change a route, you must use the
edit-route function. (For details, see
”Editing a route” starting on page 100.)
4. Repeat these steps for any more way-
points you want to add.
NOTE:
If you go to a waypoint or along a route
by using the 6000i’s GO TO function, the
unit automatically enters and organizes
the waypoints in the nav log.
Reversing your trip
You can reverse your trip at any time.
Pressing the Reverse menu key on the
NAV LOG screen lets you travel the trip in
the opposite direction.
Stopping and restarting navigation
Stopping navigation
Whenever you press the nav log’s Stop
menu key, the 6000i stops navigating, and
won’t display distance and bearing to
waypoints or ETA or ETE.
Restarting navigation
You can restart navigation along any leg or
to any waypoint of the trip. On the NAV LOG
screen, move the cursor arrow to highlight
the waypoint or leg. When you select a
waypoint, a triangle points to the waypoint.
To Next Page
