79
Reference section 4 — Creating waypoints and routes
Editing a route
Reference Manual Revision D
• otherwise, the key will read Add
new WP
.
• If you’re adding to the middle of a
route, the key is marked Insert
new WP
.
5. Repeat for each new waypoint or cursor
location you want to add to the route.
6. When you’re finished, press Cancel add.
Instead, you can press Return to switch
to list-based editing.
Removing waypoints from a route
To remove waypoints from the route (the
waypoint is not erased from the 6000i):
1. Move the cursor to the waypoint you want
to remove, then press Remove waypt.
Even if you remove all the waypoints from
a route, the 6000i still retains the empty
route. To remove the route entirely, see
Erasing an entire route, on page 80.
2. When done, press Return to go to
list-based editing.
Editing a route using a waypoints list
After you have accessed a route, as
described in Editing a route, starting on
page 76, you can add or remove waypoints
using the waypoints list as follows:
Adding waypoints to a route
1. Press the cursor pad to move the pointer
at the left side of the screen to the spot in
between two existing waypoints where
you want to insert a new waypoint.
(To add a waypoint to the beginning of
the route, be sure to position the pointer
above the first waypoint, not right onto
it.)
2. Press Insert to display the SELECT WAYPT
screen that lists all your stored waypoints.
To switch between the LOCAL and ALPHA
lists, press Next view.
Note: you can’t add an avoidance point
to a route.
3. Move the cursor to select the desired way-
point, then press ENTER to add the way-
point to the route.
Removing waypoints from a route
1. Press the cursor pad to move the
left-hand pointer directly onto the
waypoint you want to remove.
2. Press Remove.
3. Press ENTER.
To Next Page
