NTI ENTERPRISE ENVIRONMENT MONITORING SYSTEM
93
Log Settings
The Log Settings page (Figure 102) provides settings for how the ENVIROMUX will react when its Data and Event logs reach
capacity.
The Event Lo
g settings include a logging level that can be configured to log different amounts of information:
• Error : shows only system errors (like sending e-mail failures or SMS)
• Alerts: shows recorded system errors and alert messages
• Info: In addition to all of the above, the log will show less relevant information: user login/logout for example
Each log can be assigned to a group and any user that receives messages from that group can be notified when capacity is being
reached.
The log can be set to either:
• Discontinue- stop logging information
• Clear and restart- delete all log entries and restart with new entries
• Wrap- continue logging but delete the oldest entries so new ones can be recorded
The Data and/or Event log
can be set to send alerts to
users via email, syslog,
and/or SNMP traps once it
has reached 90% of
capacity, allowing them time
to react.
The Data log can also be set
to send log entries via email,
syslog, or SNMP traps to
users in addition to the
entries it records internally.
Enable Remote Logging for
email, syslog, or SNMP as
desired.
Figure 102- Log Settings page
Apply a checkmar
in this box
to enable the recording of logs
to the flash drive.
Note: Be sure to remove the
checkmark before removing a
flash drive from the
ENVIROMUX.
Otherwise data on the drive
may be lost.
To Next Page
Loading...
Need help?
General
