NTI ENTERPRISE ENVIRONMENT MONITORING SYSTEM
43
Many of the settings found in the RS485 configuration page are not present because they do not apply to contact sensors. As
such, only “Critical Alert Settings” apply (see descriptions on page 36) and non-critical alert settings are omitted altogether.
Figure 42- Contact Sensor configuration page
Aside from the usual Description, Group, and Refresh Rate settings to be applied, the configuration page introduces three new
settings:
Normal Status: This will be the contact sensors state when it is not in alert, either with contact closed, or contact open.
Enable Tamper Alert: If the contact sensor has a tamper feature, and the feature is being connected to the ENVIROMUX, then
this box can be selected if alert messages are desired in the event the contact sensor tamper feature’s state changes from its
defined “Normal Status”.
Tamper Normal Status: This will be the normal state of the contact sensor’s tamper feature when not being tampered with.
To Next Page
Loading...
Need help?
General
