NTI ENTERPRISE ENVIRONMENT MONITORING SYSTEM
104
2. Fill in Network Page (page 60) with valid information:
A. SMTP Server - check with your service provider as to what this should be.
Sometimes it is just the name of the provider (gmail.com), sometimes characters are added (mail.gmail.com,
smtp.gmail.com, smtp-mail.gmail.com, etc)
B. The default port is 25. If authentication is required, a different port number may be required. Check with
your service provider.
C. Check “Use SSL” if your SMTP server requires SSL.
D. Check “Use STARTTLS” if your SMTP server requires STARTTLS.
E. Check “Use Authentication” if SMTP server requires authentication to send emails.
a. If required, Enter “Username” and “Password” that has been assigned to ENVIROMUX.
Make sure they apply to the email address applied in the Enterprise Setup Page.
Example: username@gmail.com Most servers (not all, check with your service provider) use just the characters in front of
the “@” for your Username on the account. These, and only these characters should be entered into the “Username” block.
Note: Passwords are case sensitive. Be sure to apply the password exactly as it is required by the server.
3. Verify User is configured to receive notifications for at least one sensor group as well as having “E-Mail Alerts” selected
and a valid E-Mail address to send the notifications to.
Figure 108- Configure user to receive alerts via email
To Next Page
Loading...
Need help?
General
