CHAPTER 18
QUICK CHANGE POWER PAC
87
QUICK CHANGE POWER PAC
The Quick Change Power Pac for your machine allows you to change from one power
source to another very quickly. For example, it is useful for people who need to run their
machine at the jobsite with a gas engine and use it in a factory or indoor setting as well. It
requires two people to lift the Power Pac out of and into the machine. To change the
power pac see below.
Refer to Figure 82
POWER PAC REMOVAL
1. Remove the screws holding the #1 Left Cover on the machine. Set cover aside.
2. Using a 9/16” wrench, remove the two “A” bolts and set aside for later use.
3. Separate the Male /Female Connectors of the Main Communication Cable by
unscrewing them from each other.
4. Un-couple the Large and Small Quick Disconnect hydraulic fittings.
5. Using the two handles, have someone help you lift the Quick Change Power Pac
out of the machine and set it aside.
POWER PAC INSTALLATION
1. Using the two handles provided, have someone help you lift the new Power Pac
into position on the machine.
2. Align the two mounting holes under the handles of the Power Pac to the threaded
holes in the frame of the machine. Use the two mounting bolts “A” removed
above to fasten the Power Pac into place and tighten with the 9/16” wrench.
3. Locate the Male and Female Main Communication Cable and fasten them
together. Note that there is a notch in one and a key in the other that must be
aligned for the two to mate together correctly.
4. Connect the Large and Small Quick Disconnect fittings.
To Next Page
Loading...