CHAPTER 19
TROUBLESHOOTING
92
SOLUTION #2: Make sure that the shear blades and dies are well lubricated on
both sides with the proper lubricant (See GENERAL MAINENANCE on
page 6).
6. Manual Control Panel buttons do not work.
SOLUTION #1: Check fuse inside of Manual Control Box. Replace if blown with
a 10-amp time delay fuse (Figure 8 on page 15).
SOLUTION #2: If you have a gasoline engine, check the condition of the battery.
The control system requires 12 volts to operate properly. Replace or
charge battery as required.
To Next Page
Loading...