MPC5777M Microcontroller Data Sheet, Rev. 6
Document revision history
NXP Semiconductors158
3 3/2014
Electrical characteristics—Power management: PMC, POR/LVD, sequencing
Figure 20 (Recommended supply pin circuits):
• For VDD_LV supply: Changed "nxClv" to "Clv."
Table 35 (Device power supply integration):
•C
HV_IO
removed footnote.
•C
HV_FLA
parameter, added footnote “Start-up time of the internal flash regulator from
release of the LVD360 is worst case 500 us. This is based on the typical CHV_FLA bulk
capacitance value.”
•C
LV
: Changed the 3 for Bypass capacitance at pin to "Note3." Changed parameter
"Bypass capacitance at pin" to "Total bypass capacitance at external pin."
• Significantly revised C
HV_PMC_BYP
, including changing spec name to C
HV_PMC
, min
value to 2.2 µF (was 200 nF), and typ value to 4.7 µF (was “—”). Added footnote "For
noise filtering it is recommended to add a high frequency bypass capacitance of 0.1 µF
between VDD_HV_PMC and VSS_HV."
Table 36 (Flash power supply):
•V
DD_HV_FLA
, after trimming, Min value “3.2” changed to “3.15”. Added two notes.
• Removed I
REG_FLA
specification.
Table 39 (Functional terminals state during power-up and reset):
• Changed “TRST” to “JCOMP.”
Table 76. Revision history (continued)
Revision Date Description of changes
To Next Page
Loading...
