NXP Semiconductors MPC5777M - Electrical characteristics; Absolute maximum ratings

MPC5777M Microcontroller Data Sheet, Rev. 6
Electrical characteristics
NXP Semiconductors20
3 Electrical characteristics
3.1 Introduction
This section contains detailed information on power considerations, DC/AC electrical characteristics, and AC timing
specifications.
In the tables where the device logic provides signals with their respective timing characteristics, the symbol “CC” (Controller
Characteristics) is included in the “Symbol” column.
In the tables where the external system must provide signals with their respective timing characteristics to the device, the symbol
“SR” (System Requirement) is included in the “Symbol” column.
NOTE
Within this document, V
DD_HV_IO
refers to supply pins V
DD_HV_IO_MAIN
,
V
DD_HV_IO_JTAG
, V
DD_HV_IO_FLEX,
V
DD_HV_IO_FLEXE
, V
DD_HV_IO_EBI
, and
V
DD_HV_FLA
. V
DD_HV_ADV
refers to ADC supply pins V
DD_HV_ADV_S
and
V
DD_HV_ADV_D
. V
DD_HV_ADR
refers to ADC reference pins V
DD_HV_ADR_S
and
V
DD_HV_ADR_D
. V
SS_HV_ADV
refers to ADC ground pins V
SS_HV_ADV_S
and
V
SS_HV_ADV_D
. V
SS_HV_ADR
refers to ADC reference pins V
SS_HV_ADR_S
and
V
SS_HV_ADR_D
.
3.2 Absolute maximum ratings
Table 6 describes the maximum ratings of the device.
Table 6. Absolute maximum ratings
1
Symbol Parameter Conditions
Value
Unit
Min Max
Cycle SR Lifetime power cycles — — 1000 k —
V
DD_LV
SR 1.2 V core supply voltage
2,3,4
—–0.31.5V
V
DD_LV_BD
SR Emulation module voltage
2,3,4
—–0.31.5V
V
DD_HV_IO
SR I/O supply voltage
5,6
—–0.36.0V
V
DD_HV_PMC
SR Power Management Controller
supply voltage
5
—–0.36.0V
V
DD_HV_FLA
SR Flash core voltage
7
—–0.34.5V
V
DDSTBY
SR RAM standby supply voltage
5
—–0.36.0V
V
SS_HV_ADV
8
SR SAR and S/D ADC ground voltage Reference to V
SS_HV
–0.3 0.3 V
V
DD_HV_ADV
9
SR SAR and S/D ADC supply voltage Reference to corresponding
V
SS_HV_ADV
–0.3 6.0 V
V
SS_HV_ADR
10
SR SAR and S/D ADC low reference Reference to V
SS_HV
–0.3 0.3 V
V
DD_HV_ADR
11
SR SAR and S/D ADC high reference Reference to corresponding
V
SS_HV_ADR
–0.3 6.0 V
V
DD_HV_IO_JTAG
SR Crystal oscillator, FEC MDIO/MDC,
LFAST, JTAG
5
Reference to V
SS_HV
–0.3 6.0 V