Oce TDS400 - Language; Help; Command Line Parameters

140 Océ TDS400 User Manual
Language
From the ‘View’ menu, select ‘Language’, to select one of the supported
languages.
Note: The check mark in front of the language indicates that this is the active
display language.
▼ Set the languages
1
From the ‘View’ menu, select ‘Language’.
You have to change the display language setting in the Settings Editor, to
change the languages in the scanner and printer operator panels, and in the
local applications.
Help
▼ Display help information
1
Open the ‘Help’ menu and select ‘Contents’.
Now you can find help for all functions of the Océ Remote Logic®
applications.
Command line parameters
In order to start the remote applications faster, there are 6 command line
parameters available.
configfile=<config_file> Sets the configuration file to use.
server=server Sets the specified server as the server to connect to.
language1=lang Specifies the first language in combination with the
parameter ‘country1=country’
.
country1=country
Specifies the first language in combination with the
parameter ‘language1=language
’.
language2=lang
Specifies the second language in combination with the
parameter ‘country2=country’
.