Oce TDS400 - Select the Use of Roll 1 or Roll 2 or Manual Feed

56 Océ TDS400 User Manual
▼ Select the number of copies
1
Enter the number of copies (1 up to 99) with the ‘+’ or ‘-’ key on the scanner
operator panel.
The display shows the number of copies.
Select the use of roll 1 or roll 2 or manual feed
You can select between two rolls or manual feed with the ‘media’ key. When
a roll is selected, the copy material is taken from the selected roll.
Note: Only use paper as specified in ‘List of available material types and sizes’
on page 214.
▼ Select roll 1, roll 2
1
Press the ‘media’ key until the indicator that matches your selection lights.
2 Enter the media width if you have selected ‘Manual feed’ (see ‘Media type and
size on the printer’ on page 29).
3 Set the correct media type settings (see ‘Set the media type settings’ on
page 30).
4 Press the confirm key.