38 Océ TDS400 User Manual
Configuration
Select a language
On the operator panel of the Océ TDS400 Printer you can indicate which
language you use to display the printer information, like status and error
messages.
▼ Select a language
1
Press the On-line key to put the printer off-line.
2 Select the ‘Configuration’ item with the or key.
3 Press Next/select to enter the ‘Configuration’ menu.
4 Select ‘Language’ with the or key.
5 Press Next/select to enter the ‘Language’ menu.
6 Select the desired language with the or key.
7 Press Next/select to confirm the selected language.
8 Press On-line to put the printer on-line again.
9 Turn the printer ‘off’ and ‘on’ again.
Network settings
The Océ TDS400 has 2 network adapters. To set the network settings you must
enter the network data in 4 fields.
■ Use DHCP server. The Dynamic Host Configuration Protocol (DHCP) is a
protocol to automate the assignment of Internet Protocol (IP) addresses in a
network. Without DHCP, the IP address must be entered manually.
■ IP address. An IP address has two parts: one part identifies the network (with
the network number)and the other part identifies the specific machine or host
within the network (with the host number).
■ Subnetmask. A subnet (short for ‘subnet work’) is an identifiably separate
part of an organization's network. To manage routing that could and should
be handled within an organization.
■ Set default gateway A gateway is a network point that acts as an entrance to
another network.
Press the following key sequence to enter the System menu on the printer to set
the network settings.
To Next Page
Loading...
