Oce TDS400 - Adjust the Leading or the Trailing Strip

Using the Océ TDS400 to Copy 65
▼ Select standard cut
1
Press the Extra key.
2 Select ‘Paper copy’ with the or key.
3 Press key, to enter the ‘Paper copy’ menu.
4 Select ‘cut length’ with the or key.
5 Press key, to enter the ‘cut length’ menu.
6 Select a standard paper format with the or key.
7 Press the ‘confirm’ key.
Adjust the leading or the trailing strip
To increase the copy length to accommodate for a filing strip select a positive
leading or trailing strip.
If you do not want the filing strip to show on the copy, select a negative leading
or trailing strip. The adjustment steps are indicated on the operator panel,
expressed in millimetres or 0.1 inches.
▼ Adjust the leading or the trailing strip
1
Press the ‘strip’ key to toggle between ‘leading’ and ‘trailing’ strip.
2 Select a positive or negative value in steps of 10 mm with the or key.
3 Select a positive or negative value in steps of 1 mm with the or key.
The length of the selected strip is shown in the display. If the adjustment differs
from the default setting, the indication lights.
Attention: If you make the strip larger than the strip on the original, you can
lose information.