Using the Océ TDS400 to Scan-to-file 77
Settings to scan
Press the Extra key on the scanner operator panel to access the settings to make
a scan. The following options are available in the ‘File’ menu:
Destination You can store your scan either in the temporary storage on the
controller or you can store it on a network destination. You can define a
maximum of six destinations in the Scan Manager application. You can select
one of these destinations on the scanner operator panel.
Checkprint A Checkprint is a print from the scanned original. You can turn the
checkprint on or off.
File resolution The Océ TDS400 Scan Logic® option can scan three
resolutions: 200, 300 or 400 dots per inch (DPI). The higher the resolution, the
better the image quality. Higher resolution also causes larger file size.
File format To define the internal order of the scanned files, select between
TIFF (Tagged Image File Format), CALS-I (Continuous Acquisition and Life
Cycle support), or PDF (Portable Document Format).
Optimize size Select this option to decrease the size of the file or to get good
quality.
Set the scan size In the ‘Original’ menu.
To Next Page
Loading...
