Oce TDS400 - Destinaspbtion; Checkprint; Resolution

78 Océ TDS400 User Manual
Destinaspbtion
You can store your scan either in the temporary store on the controller or on a
network destination. You can define up to six destinations in the Océ Scan
Manager application. On the scanner operator panel you can choose one of
these destinations.
▼ Select a destination
1
Press the Extra key.
2 Select ‘Destination’ with he or key.
3 Press the key, to enter the ‘Destination’ menu.
4 Select the needed ‘Destination’ with he or key.
5 Press the Confirm key.
Note: The names of the destinations can be any. However, for your
convenience, you are able to define understandable nicknames in the Océ Scan
Manager application (see ‘Create a local destination’ on page 86).
Checkprint
A Checkprint is a print from the scanned original. You can turn Checkprint on
or off.
▼ Select Checkprint
1
Press the Output key to select ‘file’.
2 Press the Extra key.
3 Select ‘Checkprint’ with he or key.
4 Press the key, to enter the ‘Checkprint’ menu.
5 Select ‘on’ or ‘off’ with the or key.
6 Press the Confirm key.
Resolution
The Océ TDS400 Scan Logic® option can scan three resolutions:
■ 200 dots per inch (dpi)
■ 300 dpi
■ 400 dpi
To reach the best print quality on the Océ TDS400 select 300 dpi.