Oce TDS400 - Deliver Originals after Scanning; Enable Automatic Feed of the Original

60 Océ TDS400 User Manual
▼ Improve the copy quality according to the type of image
1
Press the Extra key.
2 Select ‘Original type’ with the or key.
3 Press the key to enter the ‘Original type’ menu.
4 Select ‘Lines/text’, ‘Blueprint’ or ‘Photo’ with the or key.
5 Press the key to enter the ‘Lines/text’, ‘Blueprint’ or ‘Photo’ menu.
6 Select the needed original type.
7 Press the confirm key.
Deliver originals after scanning
You can choose for delivery of the original at the front (rewind) or the rear side
of the scanner. Use the output at the rear side of the scanner if your originals
are:
■ thick
■ very thin
■ damaged
■ in a carrier sheet.
Therewindsettingwillreturntodefaultwhen,
■ the ‘cancel’ key is pressed,
■ the panel time out has exceeded.
▼ Enable the rewind function
1
Press the Extra key.
2 Select ‘Scanner’ with the or key.
3 Press the key, to enter the ‘Scanner’ menu.
4 Select ‘Rewind original’ with the or key.
5 Press the key, to enter the ‘Rewind original’ menu.
6 Select ‘on’ or ‘off’ with the or key.
7 Press the ‘confirm’ key.
Enable automatic feed of the original
To increase the productivity enable Automatic feed, no need to press the Start
key, except for the first original. If you disable automatic feed you must press
the Start key.