Oce TDS400 - Page 30

30 Océ TDS400 User Manual
▼ Set the media width settings
1
Press the On-line key to put the printer off-line.
2 Select the ‘Media settings’ item with the or key.
3 Press Next/select to enter the ‘Media settings’ menu.
4 Select ‘Roll 1’or ‘Roll 2’ with the or key.
5 Press Next/select to enter the ‘Roll’ or ‘Manual feed’ menu.
6 Select the ‘Width’ item with the or key.
7 Press Next/select to enter the ‘Width’ menu.
8 Select the desired width with the or key.
9 Press Next/select to confirm the selected width.
10 Press On-line to put the printer on-line again.
▼ Set the media type settings
1
Press the On-line key to put the printer off-line.
2 Select the ‘Media settings’ item with the or key.
3 Press Next/select to enter the ‘Media settings’ menu.
4 Select ‘Roll 1’,‘Roll 2’,‘Manual feed’ with the or key.
5 Press Next/select to enter the ‘Roll’ or ‘Manual feed’ menu.
6 Select the ‘Material’ item with the or key.
7 Press Next/select to enter the ‘Material’ menu.
8 Select the desired media material with the or key.
9 Press Next/select to confirm the selected media material.
10 Press On-line to put the printer on-line again.