Oce TDS400 - Page 43

Using the Océ TDS400 to Print 43
Sensor not free
Remove paper
Press <on-line>
The paper of one of the rolls is transferred after the marker (see
‘Feed the material’ on page 155) when power is applied to the
printer.
Take the paper back.
Press <on-line>
Paper retracted
Press <on-line>
Put the paper into the manual feed.
Press <on-line>
Copy too short
Remove paper
Press <on-line>
The length of the print material is less than 420 mm. This can oc-
cur with the manual feed.
Use an original longer than 420 mm.
Inputflap open
Close inputflap
The input flap is open.
Close the input flap.
Inputflap open
Remove paper
Press <on-line>
The input flap is open during the print process
Remove the paper and press <on-line>.
Roll 1 empty
Open roll unit
The paper on roll 1 is empty.
Open the roll unit and replace it.
Roll 2 empty
Open roll unit
The paper on roll 2 is empty.
Open the roll unit and replace it.
Wait for folder The communication between the printer and the folder starts up.
Folder is off The communication between the printer and the folder was not es-
tablished.
Folder belt full The belt of the folder is full.
Empty the belt of the folder.
RU tape empty The tape roll of the reinforcement unit is empty.
Open the reinforcement unit and replace the empty tape roll.
Status Messages (continued)
Status messages Explanation