Oce TDS400 - Page 91

Using the Océ TDS400 to Scan-to-file 91
▼ Delete a scanned file
1
Select a file in the right pane.
2 From the ‘File’ menu select ‘Delete’ or click the ‘Delete’ button on the toolbar
(see Figure 25).
[25] ‘Delete’ button on the toolbar.
The selected file will be deleted.
Note: This option is only available if you are logged on as a Key operator
or as a Repro operator.
▼ View properties of a scanned file
1
Select a file in the right pane.
2 From the ‘File’ menu select ‘Properties’ or click the ‘Properties’ button on the
toolbar (see Figure 26).
[26] ‘Properties’ button on the toolbar.
The following window appears (see ‘‘Scanfile properties’ window’ on
page 91):
[27] ‘Scanfile properties’ window
3 Click ‘OK’ to close the ‘Scanfile properties’ window.