94 Océ TDS400 User Manual
Note: As there is no registered user, you can press Enter to initiate the
connection.
5 Set the transmission mode to binary by entering ‘binary’.
6 Go to the ‘tempstore’ directory using the following command: ‘cd tempstore\’.
7 Go to the ‘scan’ directory if you want to retrieve a file from a destination on
the local host,
or
go to the ‘unsent’ directory if you want to retrieve a file from ‘unsent’ folder
on the local host.
8 Get the data file (for example: bugatti.tif) via the ‘get’ command:
‘get bugatti.tif’.
9 Quit FTP by entering the ‘bye’ command.
Note: You can retrieve multiple files by the ‘mget *’ command or the ‘mget .‘
command. Which command you can use is release dependent.
To Next Page
Loading...
