44473001TH Rev.1
66 /
Oki Data CONFIDENTIAL
3. MFP INSTALLATION
Loading Paper in Tray 1 and Tray 2
The following procedure explains how to load
paper in tray 1 or tray 2 (optional).
Note! The following procedure uses tray 1 as an example.
Reference To
load custom size paper on the tray, need to register the size in [Paper
Setup].
(1
) Flex paper back and forth, and then fan it. Straighten the edges of the paper stack
on a level surface.
(2
) Pull out the paper tray.
(3) Slide the paper width guide to the width of paper to be loaded.
(4) Slide the paper stopper to the length of paper to be loaded.
If loading legal size paper, pull out the sub support and then slide the paper stopper.
To Next Page
Loading...
Need help?
General
