5238-E P-340
SECTION 15 APPENDIX
M124 STM time over check ON ✩
M125 STM time over check OFF ✩
M126 Additional air blower 3 OFF ✩
M127 Additional air blower 3 ON ✩
M128 Tailstock swing retract ✩
M129 Tailstock swing advance ✩
M130 Chucking error detecting air output OFF ✩
M131 Chucking error detecting air output ON ✩
M132 Chucking error detection OFF ✩
M133 Chucking error detection ON ✩
M134 Z-axis thrust monitoring OFF ✩
M135 Z-axis thrust monitoring ON ✩
M136 Shape designation for compound fixed cycle ✩
M137 Touch setter interlock release ON ✩
M138 Touch setter interlock release OFF ✩
M139 Lead machining function - learning operation ✩
M140 Tapping cycle M-tool constant rotation answer ignored ✩
M141 C-axis clamp or not selection ✩
M142 Coolant pressure, low ✩
M143 Coolant pressure, high ✩
M144 Additional coolant 1 OFF ✩
M145 Additional coolant 1 ON ✩
M146 C-axis unclamp ✩
M147 C-axis clamp ✩
M148 Pick-off spindle start, CW ✩
M149 Pick-off spindle start, CCW ✩
M150 Synchronized rotation OFF ✩
M151 Synchronized rotation ON ✩
M152 M-tool spindle interlock ON ✩
M153 M-tool spindle interlock OFF ✩
M154
Additional air blower 2 OFF
(air blower for gauging)
✩
M155
Additional air blower 2 ON
(air blower for gauging)
✩
M156 Center work interlock OFF
M157 Center work interlock ON
M158 Lead machining function - synchronized operation OFF ✩
M159 Lead machining function - synchronized operation ON ✩
M160 Cancel of M161
M161 Feedrate override fix (100%)
M162 Cancel of M163 ✩
M163 M-tool spindle speed override fix (100%) ✩
M164 Cancel of M165
M165 Ignoring slide hold and single block ✩
M Code Contents
To Next Page