5238-E P-341
SECTION 15 APPENDIX
M166 Ignoring tailstock spindle advance/retract interlock OFF ✩
M167 Ignoring tailstock spindle advance/retract interlock ON ✩
M168 Ignoring M-tool spindle constant speed answer ✩
M169 C-axis not clamped ✩
M170
M171
M172 Robot inside the lathe interlock release OFF ✩
M173 Robot inside the lathe interlock release ON ✩
M174 Additional coolant 2 OFF ✩
M175 Additional coolant 2 ON ✩
M176 Y-axis unclamp ✩
M177 Y-axis clamp ✩
M178 Tailstock chuck clamp
M179 Tailstock chuck unclamp
M180 Robot request 0 ✩
M181 Robot request 1 ✩
M182 Robot request 2 ✩
M183 Robot request 3 ✩
M184 Chuck internal interlock release OFF ✩
M185 Chuck internal interlock release ON ✩
M186
M187
M188 Tailstock joint OFF (tow-along programmable tailstock) ✩
M189 Tailstock joint ON (tow-along programmable tailstock) ✩
M190 Designation of G00 possible with tailstock joint ✩
M191 Designation of M-tool spindle orientation direction, CW ✩
M192 Designation of M-tool spindle orientation direction, CCW ✩
M193 Cancel of M194 ✩
M194 Phasing for thread cutting ✩
M195 Cancel of M196 ✩
M196 Thread cutting phasing stroke effective ✩
M197 Thread cutting phasing stroke clear ✩
M198
M199
M200 Z-axis synchronized feed cancel ✩
M201 Z-axis synchronized feed, G13 ✩
M202 Z-axis synchronized feed, G14 ✩
M203 Turret unclamp (NC turret) ✩
M204 LR15M-ATC; time reduction (magazine shutter close) ✩
M205 LR15M-ATC; time reduction (magazine shutter open) ✩
M206 LR15M-ATC; time reduction (retract position cover close) ✩
M207 LR15M-ATC; time reduction (retract position cover open) ✩
M208 Door interlock C, D ON
M209 Door interlock C, D, OFF
M Code Contents
To Next Page