Olympus COBRA - Instrument Compatibility; Table 2 Ancillary Equipment

DMTA-20006-01EN, Rev. B, February 2014
Important Information — Please Read Before Use 4
The images in this manual may not be identical to your instrument model and
connector type. However, the operating principles remain the same.
Instrument Compatibility
The COBRA scanner is compatible with the Olympus ancillary equipment listed in
Table 2 on page 4.
Table 2 Ancillary equipment
Part number Item number Description
COBRA U8750053
Small pipe scanner kit with encoder to
cover 21.3 mm to 114.3 mm pipe outside
diameters (OD). Packaged in hard carrying
case.
2.25CCEV35-A15C-P-2.5-OM
a
U8331117
2.25 MHz low profile phased array probe
with 16 elements, 0.5 mm pitch, and 10 mm
elevation.
The elements are curved on the elevation
with a 35 mm radius.
The cable is 2.5 m long with OmniScan
connector.
3.5CCEV35-A15C-P-2.5-OM
a.
U8331149
3.5 MHz low profile phased array probe
with 16 elements, 0.5 mm pitch, and 10 mm
elevation.
The elements are curved on the elevation
with a 35 mm radius.
The cable is 2.5 m long with OmniScan
connector.