Olympus COBRA - Table 7 Wedge Selection Chart

DMTA-20006-01EN, Rev. B, February 2014
Accessories and Spare Parts 55
C1-LF-BXM-0.3M U8769010
0.3 m long adapter LEMO female
to Bendix male linking LEMO
encoder cable to Focus LT.
C1-DE15F-BXM-0.30M U8767107
0.3 m long adapter DE-15 female
to Bendix male linking DE-15
encoder cable to Focus LT.
OmniScan PA or FOCUS LT —
Many OmniScan and FOCUS LT
instrument models can be used.
b, c
a. SA15C casings are based on the same design as the A15 but are 2 mm (0.08 in) taller, increas-
ing height clearance.
b. Encoder cable adaptor may be required (see Table 12 on page 62).
c. A two-sided COBRA scanner must be used with a multi-group instrument.
Table 7 Wedge selection chart
Wedge part number
Wedge AOD
a
a. axial outside diameter (AOD)
Pipe min. OD
b
b. outside diameter (OD)
Pipe max. OD
b
(in.) (mm) (in.) (mm) (in.) (mm)
SA15-N60S-IH-AOD0.84 0.840 21.3 0.800 20.3 0.840 21.3
SA15-N60S-IH-AOD1.05 1.050 26.7 0.840 21.3 1.050 26.7
SA15-N60S-IH-AOD1.315 1.315 33.4 1.050 26.7 1.315 33.4
SA15-N60S-IH-AOD1.66 1.660 42.2 1.315 33.4 1.660 42.2
SA15-N60S-IH-AOD1.9 1.900 48.3 1.660 42.2 1.900 48.3
SA15-N60S-IH-AOD2.375 2.375 60.3 1.900 48.3 2.375 60.3
SA15-N60S-IH-AOD2.875 2.875 73.0 2.375 60.3 2.875 73.0
SA15-N60S-IH-AOD3.5 3.500 88.9 2.875 73.0 3.500 88.9
SA15-N60S-IH-AOD4 4.000 101.6 3.500 88.9 4.000 101.6
SA15-N60S-IH-AOD4.5 4.500 114.3 4.000 101.6 4.500 114.3
Table 6 COBRA Scanner ordering part numbers (continued)
Part number Item number Description
Package
COBRA-K-4.5