DMTA-20006-01EN, Rev. B, February 2014
Important Information — Please Read Before Use
3
Important Information — Please Read Before Use
Intended Use
The COBRA scanner is designed to perform nondestructive inspections of welds on
industrial and commercial cylindrical parts. The COBRA scanner is a manual scanner
for pipes with diameters ranging from 21.3 mm to 114.3 mm (0.84 in. to 4.50 in.). It is
designed to provide the encoded position of the probes on the circumference around
the pipe.
The COBRA scanner is intended for both dual-and single-probe scanning
applications. The COBRA scanner is intended to operate in an environment as
described in Table 11 on page 62.
Do not use the COBRA scanner for any purpose other than its intended use. It must
never be used to inspect or examine human or animal body parts.
Instruction Manual
This instruction manual contains essential information on how to use this Olympus
product safely and effectively. Before using this product, thoroughly review this
instruction manual. Use the product as instructed.
Keep this instruction manual in a safe, accessible location.
To Next Page
Loading...
