Olympus COBRA - Ordering Part Numbers

DMTA-20006-01EN, Rev. B, February 2014
Chapter 4 52
4.1 Ordering Part Numbers
Table 6 on page 52 provides the part numbers for the COBRA scanner. Table 7 on
page 55 presents the wedge selection chart to select the wedge that is appropriate for
the outside diameter of the pipe to inspected.
Table 6 COBRA Scanner ordering part numbers
Part number Item number Description
Package
COBRA-K-4.5
COBRA U8750053
Small pipe scanner kit with
encoder to cover 21.3 mm to
114.3 mm pipe outside diameters
(OD). Packaged in hard carrying
case.

2.25CCEV35-A15C-P-2.5-
OM
a
U8331117
2.25 MHz low profile phased array
probe with 16 elements, 0.5 mm
pitch, and 10 mm elevation.
The elements are curved on the
elevation with a 35 mm radius.
The cable is 2.5 m long with
OmniScan connector.
3.5CCEV35-A15C-P-2.5-OM U8331149
3.5 MHz low profile phased array
probe with 16 elements, 0.5 mm
pitch, and 10 mm elevation.
The elements are curved on the
elevation with a 35 mm radius.
The cable is 2.5 m long with
OmniScan connector.
5CCEV35-A15-P-2.5-OM U8331163
5 MHz low profile phased array
probe with 16 elements, 0.5 mm
pitch, and 10 mm elevation.
The elements are curved on the
elevation with a 35 mm radius.
The cable is 2.5 m long with
OmniScan connector.