Olympus COBRA - Figure 1-3 Link Types; Figure 1-4 Pipe-To-Component Interface Inspection with the One-Sided Scanner Configuration

DMTA-20006-01EN, Rev. B, February 2014
COBRA Scanner Description 17
Figure 1-3 Link types
Referring to Figure 1-2 on page 16, the tail component on the right-hand side includes
the encoder that provides the position of the scanner around the pipe. You can also
use only the encoder side of the scanner to inspect the pipe-to-component interfaces
(see Figure 1-4 on page 17).
Figure 1-4 Pipe-to-component interface inspection with the one-sided scanner
configuration
Small male link
Female link
Half link
Medium link
Long link