Olympus COBRA - Page 12

DMTA-20006-01EN, Rev. B, February 2014
Important Information — Please Read Before Use 6
COBRA-SP-BASIC U8775166
Basic spare parts kit (see Figure 4-2 on
page 57)
COBRA-SP-FULL U8775188
Basic spare parts kit, plus links and the
encoder assembly
COBRA-SP-SA15 U8750056
One of each of the eleven wedges needed
for coverage of 21.3 mm to 114.3 mm
(0.84 in. to 4.50 in.) pipe outside-diameter
range.
OMNI-A2-SPLIT128 U8100133
Y-adaptor (splitter) to support two phased
array probes on OmniScan MX2
instruments with PA2 128 elements
module.
OMNI-A2-SPLIT64 U8100135
Y-adaptor (splitter) to support two phased
array probes on OmniScan MX2
instruments with PA2 64 elements module.
OMNI-A-ADP05 U8767016
Y-adaptor (splitter) with OmniScan
connectors to support two phased array
probes
E128P0-0000-OM U8800428
Phased array cable extensions required to
interface between the Omni-A-ADP05 and
an OmniScan MX2 instrument with PA1
128 elements module.
EIB64-NT-0-P-0-OM U8779452
Interbox to support 2 phased array probes
on OmniScan MX2 instruments with PA1
64 elements module.
WTR-SPRAYER-4L U8775153
4 ℓ manual water pump with couplant
tubes and fittings
Omni-A2-ADP20 U8775201
Scanner interface adaptor to connect
scanners encoder cables with DE-15
connector to OmniScan MX2 with LEMO
connector scanner interface.
Omni-A-ADP27 U8780329
Scanner interface adaptor to connect
scanners encoder cables with LEMO
connector to OmniScan MX with DE-15
connector scanner interface.
C1-LF-BXM-0.3M U8769010
0.3 m long adapter LEMO female to Bendix
male linking LEMO encoder cable to
Focus LT.
Table 2 Ancillary equipment (continued)
Part number Item number Description