Olympus COBRA - Page 74

DMTA-20006-01EN, Rev. B, February 2014
List of Figures 68
Figure 2-19 Loosening the links ............................................................................................ 36
Figure 2-20 Separating the two halves of the scanner ....................................................... 37
Figure 2-21 The graduated crossbar ..................................................................................... 38
Figure 2-22 Example of tail configured to the 2.0 position ............................................... 39
Figure 2-23 The probe holder shown in the extended position ....................................... 39
Figure 2-24 Wrapping and holding the scanner ................................................................. 40
Figure 2-25 Placing the wedge-separation indicator ......................................................... 42
Figure 2-26 Bringing the wedge faces together .................................................................. 42
Figure 2-27 Reading the wedge separation ......................................................................... 43
Figure 2-28 Installing the scanner on the pipe ................................................................... 44
Figure 2-29 The couplant valve (shown open) ................................................................... 45
Figure 2-30 Rotating the scanner .......................................................................................... 46
Figure 4-1 The wedge part number .................................................................................... 56
Figure 4-2 Content of the basic spare part kit (P/N: COBRA-SP-BASIC) ..................... 57
Figure 4-3 Exploded view .................................................................................................... 58
Figure 5-1 LEMO connector pinout diagram ................................................................... 63