4.12 LCG replacement indicator
95
OER-Elite OPERATION MANUAL
Ch.4
When this setting is activated, the reprocessor counts a LCG day count (number of days the
disinfectant solution is effective after replacement) and a LCG usage count (number of cycles the
disinfectant solution is effective after replacement) after Loading LCG process. In addition, the
reprocessor displays the disinfectant replacement indicator when the day counts or the usage counts
reach each set value. You can set the number of days and the maximum number of disinfection cycles
prior to replacement of the disinfectant solution. The reprocessor indicates the replacement timing
when the set value for the elapsed days or operations is reached as a reference or reminder for
disinfectant solution replacement. Note that this reprocessor does not determine the degradation of the
disinfectant concentration. It is recommended to update the set value according to changes in the
operating environment, etc.
Be sure to check a concentration of the disinfectant solution by using a separately
available test strips. The LCG replacement indicator does not determine the
effectiveness of the disinfectant solution. The expiration of the disinfectant solution
varies depending on many factors including the time after activation, the
temperature of the environment where the reprocessor is installed, and the number
and types of endoscopes that have been reprocessed. The LCG replacement
indicator does not take these and other factors into consideration.
• For details of indicator, refer to Section 3.2, “Alarm indicator”.
• When replace the consumable item after changing date and time, the disinfectant
solution replacement indicator might not be displayed incorrectly.
4.12 LCG replacement indicator
To Next Page
Loading...
