Entering the patient ID by the optional bar code
To input the patient ID from a bar code, it is required to connect the optional MAJ-2130 bar code
reader.
For the installation of the bar code reader, refer to the Instructions - Installation Manual for this
reprocessor and the Instructions for the MAJ-2130 bar code reader.
Do not connect anything other than the designated bar code reader to the bar code
port. Otherwise, the IDs may not be read out correctly or the instrument may
malfunction.
• A patient ID can be input by either bar cord reader or software keyboard
(on-screen), but a patient name can be input only by the software keyboard. It is
possible to input the patient name by software keyboard (on-screen) after entering
the patient ID by the bar code reader.
• The OER-Elite can read the top 23 characters of each bar code. When the bar
code contains data other than patient data, the reprocessor reads all of
23 characters including data other than the patient data that a bar code has.
• Do not alter the settings of the bar code reader. It has been set to the optimum
settings for combined use with this reprocessor. If the Settings are altered, it may
be impossible to read the bar code, contact Olympus.
To Next Page
Loading...
