Important Information — Please Read Before Use
13
OER-Elite OPERATION MANUAL
Equipment compatibility
Use the OER-Elite in combination with ancillary equipment listed in “System chart” on page 647. Using
incompatible equipment may result in patient or operator injury and equipment damage and/or
malfunction.
Olympus has not tested the efficacy of reprocessing on the OER-Elite in combination with endoscopes
that are not listed on the “List of compatible Endoscopes/Connecting Tubes <OER-Elite>”.
If using endoscopes that are not listed on the “List of compatible Endoscopes/Connecting Tubes
<OER-Elite>”, reprocessing of endoscopes may be insufficient.
Care and storage
After use, reprocess and store this reprocessor referring to the instructions in Chapter 10, “End-of-Day
Checks” in this manual. Inappropriate care and storage could present an infection control risk and/or
cause reprocessor damage or malfunction.
Maintenance and Inspection
• The OER-Elite requires routine maintenance and inspection. In addition to checks before use,
the person in charge of maintenance and administration of the medical equipment at the
facility should periodically check all of the items described in this manual. If any irregularity is
found, do not use the reprocessor and inspect it as described in Section 13.2,
“Troubleshooting guide”. If the irregularity is still present, the reprocessor must be repaired
prior to next use.
• If the PERIODIC MAINTENANCE indicator starts to indicate on the touch screen, described
in Section 2.7, “Control panels”, the time for regularly scheduled maintenance is near. Contact
Olympus to perform the maintenance.
Repair and modification
Do not disassemble, modify, or attempt to repair this reprocessor and its accessories. Doing so could
result in operator or patient injury and/or equipment damage or malfunction. Some problems that
appear to be malfunctions may be corrected by referring to Chapter 13, “Troubleshooting and Repair”.
If the problem cannot be resolved using the information in Chapter 13, “Troubleshooting and Repair”,
contact Olympus.
To Next Page
Loading...
