Outline of Functions
17
OER-Elite OPERATION MANUAL
Water line disinfection
This function disinfects the water supply line and other lines inside the reprocessor. For details,
refer to Section 7.7, “Water line disinfection”.
Self disinfection and water sampling
This function disinfects the basin and internal piping of the reprocessor. End of the process,
sampling of rinse water can be performed for microbiological surveillance. For details, refer to
Section 7.8, “Self-disinfection and water sampling”.
Detergent/Alcohol line disinfection
This function disinfects the detergent line and alcohol line of the reprocessor. For details, refer to
Section 7.9, “Detergent line disinfection” and Section 7.10, “Alcohol line disinfection”.
Auto leak test
The endoscope leak test can be executed automatically by programming it in a user-configured
reprocessing process. It can also be performed as an independent operation. For details, refer
to Section 7.12, “Auto leak test”.
Manual leak test
Manual inspection for endoscope leakage during immersion of water can be performed as an
independent operation. For details, refer to Section 7.11, “Manual leak test”.
Alcohol flush
To assist in drying the channel after reprocessing, alcohol is flushed through the endoscope
channels followed by air. This function performs alcohol flush into the endoscope channels. The
alcohol flush can be executed automatically in a reprocessing process. It can also be performed
as an independent operation. For details, refer to Section 7.14, “Alcohol flush”.
Air purge
This function drains the remaining fluid from the basin after an irregularity occurs, or if the
process is stopped before it completes. Air purge also eliminates residual fluid from the
endoscope channels. For details, refer to Section 7.6, “Air purge”.
To Next Page
Loading...
